The Uni-T UT682 Wire Tracker provides a practical solution for quickly and accurately tracing and testing cables without the need to open the insulation, making it suitable for networking, telephone, electrical work, and field fault diagnosis.
Features of the UT682 Wire Tracker Consists of a transmitter and receiver to trace cables such as LAN, telephone, coaxial, and electrical wires without damaging the insulation. Supports RJ11 and RJ45 outputs visible on the device, facilitating the inspection of telephone lines and network cables and verifying their connections. Quick testing for open and short circuits, making it a suitable choice when a cable fault detection device is needed during maintenance. Ability to use headphones via the headphone jack on the receiver for operation in noisy environments, with volume control. LED indicators for signal strength and wire sequence, with a low battery alert and dual-cycle measurement mode to enhance tracking accuracy.
Specifications of the UT682 Wire Tracker Supported cable types: LAN cable, telephone line, coaxial cable, electrical wire. Telephone cable tracking distance: up to 3000 meters. Unshielded cable tracking distance: up to 320 meters. Shielded cable tracking distance: up to 320 meters. Distribution panel wire tracking: up to 100 meters. Open and short circuit testing: supported, for quick fault identification. Distinguishing telephone lines from LAN cables and port identification: supported. DC voltage measurement and polarity indicator: range 5V to 52V, for safely checking voltage level and polarity within range. Input voltage protection for the transmitter: up to 52V DC. Wire alignment and connection sequence measurement: 9 LED indicators with fast or slow measurement speed selection. Transmitter output: 12V peak to peak. Transmitter low battery indicator: at 6.6V ±0.5V. Power source: 9V battery for the transmitter and 9V battery for the receiver. Maximum current for the transmitter during operation: 25mA. Standby current for the receiver: approximately 10mA. Operating current for the receiver: less than 40mA AC RMS. Headphone jack for the receiver: supported for operation in noisy environments. Operating environment: 0 to 40 degrees Celsius, storage: -10 to 50 degrees Celsius. Humidity: operating 20% to 75% RH, storage 10% to 90% RH. Altitude: up to 2000 meters. Color: Red and Gray. Dimensions: transmitter 125 × 48 × 28 mm, receiver 195 × 48 × 30 mm. Net weight: transmitter 125 g, receiver 153 g. Accessories: two 9V batteries, RJ11 cable. Suggested uses: cable tracing and diagnosing faults in communication, audio, and video cables, and can be utilized as a close solution to an electrical fault detection device when checking for shorts and interruptions within supported ranges. Additional functional description: The device can be practically considered as a cable fault detection tool for identifying interruptions and shorts and tracing paths in networking and telephone work.
